Marquis Spas Reward Owner's Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 74
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
START-UP PROCEDURE
Your spa is equipped with solid-state Comfort Controls specific to your spa
model. (See SPA CONTROL OPERATION for your specific spa model.)
To start your spa, you need spa test strips. It is important to follow each of
these steps when starting your spa. Once you have completed the follow-
ing steps, see MARQUIS CARE AND ENJOYMENT GUIDE for proper
water treatment.
NOTE: Your spa has been filled and test-run at the factory. The first time
your spa is filled with water, some discoloration from residual test water
may appear. This will disappear when the spa is completely filled and the
filtration system is functioning.
WARNING: Spa must be completely filled with water before turning on
power.
Test the water for the proper chemical balance and adjust as necessary.
SpaCare products are recommended. (See WATER TREATMENT.)
PROPER CHEMICAL BALANCE IS IMPORTANT for your safety and
the longevity of your spa.
In the case of relocating your spa, it is imperative to follow the instructions in
the owner’s manual. These instructions must remain with the spa. Damage
caused by relocating spa is not covered under warranty.
THERAPY PUMP(S)
Allow the spa to circulate on high-speed (see SPA CONTROL OPERA-
TION) for four to five minutes to discharge air from the plumbing system.
Do not expect hot water immediately from the jets; the heater will take
several hours to heat the water.
Start-up procedure for all models
1. Place spa on a hard, flat, level surface. Make sure the power supply is
off.
2. Make sure the suction guard(s) in the footwell are in place and undam-
aged.
3. Open the equipment door. Tighten all disconnects and open all shut-off
valves.
NOTE: Keep the drain valve closed at all times except when draining the spa (do not
rely on the cap to stop the flow of water). Not doing so could result in damage to the
drain valve due to freezing water.
14
STARTING YOUR SPA
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 73 74

Comments to this Manuals

No comments