Marquis Spas Quest Owner's Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 17
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
PAGE 4
The following instructions are required to be printed by Underwriters
Laboratories (UL) as a condition of the listing of this product. They contain
important safety information. We strongly encourage you to read and
apply them.
IMPORTANT SAFETY
INSTRUCTIONS
WHEN INSTALLING AND USING THIS ELECTRICAL EQUIP-
MENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED, INCLUDING THE FOLLOWING:
1. READ AND FOLLOW ALL
INSTRUCTIONS
2. WARNING: To reduce the risk of injury, do not permit children to use
this product unless closely supervised at all times.
3. DANGER: RISK OF CHILD DROWNING. Extreme caution must be
exercised to prevent unauthorized access by children. To avoid acci-
dents, ensure that children cannot use the spa or hot tub unless they
are supervised at all times.
120 VOLT, CORD CONNECTED MODELS
4. DANGER: RISK OF INJURY. Connect only to a grounded source.
5. Do not bury the power cord.
6. WARNING: To reduce the risk of electric shock, replace a damaged cord
immediately.
7. A ground terminal (pressure wire connector) is provided on the surface
of the control box inside the equipment compartment. This connector
should be bonded with a minimum No. 8 AWG (8.4mm
2
) solid copper
wire between this unit and any metal ladders, metal water pipes, metal
enclosures of electrical equipment, conduit, or metal equipment within
five feet (1.5m) of the spa. If the spa is located on a reinforced concrete
pad, the reinforcing steel should also be bonded to the ground terminal.
8. WARNING: Your spa is equipped with a ground fault circuit interrupter
(GFCI) on the end of the power supply cord. Before each use of the
spa, with the plug connected to the power supply and the unit operat-
ing, press the “test” button. The unit should stop operating and the
GFCI power indicator will go out. Wait thirty seconds and then reset the
GFCI by pressing the “Reset” button. The GFCI power indicator will turn
on, restoring power to the spa. If the interrupter does not perform in this
manner, it is an indication of an electrical malfunction and the possibility
of an electric shock. Disconnect the plug from the receptacle until the
fault has been identified and corrected.
safety instructions
MARQUIS SPAS
Page view 3
1 2 3 4 5 6 7 8 9 ... 16 17

Comments to this Manuals

No comments