Marquis Spas Quest Owner's Manual download pdf (Page 16)

START-UP PROCEDURE

Your spa is equipped with solid-state Comfort Con-

trols specific to your spa model. Please see SPA

CONTROL OPERATION for your specific spa model.

To start your spa, you need spa test strips. It is impor-

tant to follow each of these steps when starting your

spa. Once you have completed the following steps,

see MARQUIS CARE AND ENJOYMENT GUIDE for

proper water treatment.

NOTE: Your spa has been filled and test-run at the

factory. The first time your spa is filled with water,

some discoloration from residual test water may

appear. This will disappear when the spa is com-

pletely filled and the filtration system is functioning.

Test the water for the proper chemical balance and

adjust as necessary. SpaCare products are recom-

mended. (See WATER TREATMENT.) PROPER

CHEMICAL BALANCE IS IMPORTANT for your

safety and the longevity of your spa.

THERAPY PUMP(S)

Allow the spa to circulate on high-speed (see SPA

CONTROL OPERATION) for four to five minutes to

discharge air from the plumbing system. Do not

expect hot water immediately from the jets; the

heater will take several hours to heat the water.

Start-up procedure for all models

1. Place spa on a hard, flat, level surface. Make

sure the power supply is off.

2. Make sure the suction guard(s) in the footwell

are in place and undamaged.

3. Open the equipment door. Tighten all

disconnects and open all shut-off valves.

NOTE: Keep the drain valve closed at all times

except when draining the spa (do not rely on the

cap to stop the flow of water). Not doing so could

result in damage to the drain valve due to freezing

water.

4. Install filter cartridges. (See INSTALLATION

INSTRUCTIONS, Filter Cartridges.)

5. Fill the spa with water to two-thirds of the way

up the Vortex skimmer openings. The use of a

Fill Filter is recommended, especially in areas

with high mineral content in the water.

PAGE 16

starting your spa

Fill spa with water to

two-thirds of the way

up the Vortex skimmer

opening.

MARQUIS SPAS

Screw pump plug into

face of pump.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 70 71

Comments to this Manuals

No comments

Marquis Spas Quest Owner's Manual Page 16

Comments to this Manuals

Related products and manuals for Above ground pool accessories Marquis Spas Quest