Marquis Spas Quest Owner's Manual download pdf (Page 17)

Start-up procedure (continued)

6. Turn the power on.

7. Your spa is now in “pump priming” mode and a

“Pr” message displays in the LCD window of

the control panel. While in this mode the spa

appears idle, which lasts approximately four to

five minutes if not exited manually. To exit

manually, press the TEMP pad.

8. At this time the spa should have water flowing

from the jets. If the pump has not primed and

the water is not flowing from the jets after two

minutes TURN OFF POWER TO THE SPA and

vent air from the pumps by slightly opening the

pump unions. After turning the power on again,

the spa initiates a new priming mode. Repeat

steps above.

9. The system requires approximately two minutes

of water flow to determine the water tempera-

ture. After two minutes of water flow, the tem-

perature is displayed as actual water tempera-

ture. After you have manually exited the priming

mode (or allowed the spa to automatically exit)

the LCD window momentarily displays 102°F

(39°C) and then the display switches to - - °F.

10. The factory default setting for water tempera-

ture is 102°F (39°C). Use the TEMP pad on the

control panel to set the water temperature to

the desired level. (See SPA CONTROL OPERA-

TION.) Your spa heats at the rate of approximately

five degrees per hour for 240V systems.

DURACOVER™

When the spa is not in use, the DuraCover should be

kept on the spa to retain the water’s heat and to keep

out dirt, leaves, etc. Your heater maintains a constant

water temperature between uses.

For your safety and convenience, the cover is

equipped with adjustable straps, safety locks, and

handles. Use the exterior handles to remove and

replace your cover. Marquis suggests that you use

the safety locks to help keep out unintended users

and prevent covers from being blown off in windy

conditions. Cover Companion™ cover lifts are also

available to assist you in cover removal. (See SPA

ENHANCEMENTS at back of this manual.)

PAGE 17

starting your spa

Vent air by slightly

opening pump unions.

MARQUIS SPAS

DuraCover helps

maintain a constant

water temperature.

Use TEMP pad to set

water temperature.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 70 71

Comments to this Manuals

No comments

Marquis Spas Quest Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Above ground pool accessories Marquis Spas Quest