Marquis Spas Quest Owner's Manual download pdf (Page 43)

PLEASE NOTE: The following corrective actions

may be performed by the spa owner. If the trouble

cannot be corrected in the steps below, please

contact your Marquis spa dealer for service. (Im-

proper servicing by an unauthorized service provider

or spa owner could result in damage not covered by

the warranty and could cause serious injury.)

EQUIPMENT WILL NOT OPERATE

• Check the control panel LCD window for

diagnostic code.

• 240V Spas: Check the circuit breaker on the

main circuit panel.

• 120V Spas: Check the GFCI power cord and

reset if necessary (see IMPORTANT SAFETY

INSTRUCTIONS at beginning of manual).

• Check the condition of the power cord.

INADEQUATE JET ACTION

• Be sure the shut-off valves are completely open.

• Open the jets by turning the jet face to allow for

maximum water flow.

• Check that the air control valve is open (rotate

lever counterclockwise to open).

• Check for obstruction or restrictions at suction

guard(s) or filters, such as leaves, etc.

NO HEAT

• Check temperature displayed in the LCD window

for desired temperature setting.

• Inspect the filter cartridge(s) for dirt and debris.

• Check that the water is at proper level, 2/3 up

the Vortex skimmer opening(s).

• Check HEAT MODE to be certain spa is not in

SLEEP MODE.

• Lower ambient temperatures may result in heat loss.

NOTE: Do not expect instant hot water from the

jets. It will take the heater 12-24 hours to heat the

water to the temperature you desire.

LIGHT DOES NOT WORK

• Press the LIGHT pad on the control panel.

• Reposition the light bulb in the socket. (See

REPLACING LIGHT BULB.)

• Replace the light bulb with a 6 WATT BULB (GE

918 ONLY).

troubleshooting

PAGE 43

MARQUIS SPAS

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 70 71

Comments to this Manuals

No comments

Marquis Spas Quest Owner's Manual Page 43

Comments to this Manuals

Related products and manuals for Above ground pool accessories Marquis Spas Quest