Marquis Spas Quest Owner's Manual download pdf (Page 34)

SETTINGS

Clock

Press the CLOCK pad followed by the SETTING pad.

“Program” will be shown in the upper left corner of the

panel display and the hour will begin flashing. To

adjust, press the TEMP+ or TEMP- pad. Once the

correct hour has been set, press SETTING pad to set

the minutes. “Minutes” will flash. Follow above proce-

dure to set the correct minutes.

Filter Cycle 1:

Follow Clock programming above. Then press the

SETTING pad to enter Filter 1 programming mode.

“Program filter 1 start time” will be shown in the upper

left corner of the panel display and the hour will begin

flashing. To adjust press the TEMP+ or TEMP- pads.

Once the correct hour has been set press SETTINGS

pad to set the minutes. Follow above procedure to set

the correct minutes. Press the SETTING pad again

and “Program filter 1 end time” will be shown in the

upper left corner of the panel display and the hour will

begin flashing. Follow above procedures to set the

correct hour and minutes. NOTE: When in a filter cycle

the Filter Cycle LED will illuminate.

Filter Cycle 2:

Press SETTING pad to enter filter 2 programming

mode. “Program filter 2 start time” will be shown in the

upper left hand corner of the panel display and the

hour will begin flashing. Follow above procedure to set

the correct hour and minutes. Press the SETTING pad

again and “Program filter 2 end time” will be shown in

the upper left corner of the panel display. Follow above

procedure to set correct hour and minutes.

NOTE: Any time during the setting of features you

may exit the programming mode by pressing the

CLOCK pad. If you don not want to run any of the filter

modes or spa light cycles, set the start and end times

for the same time.

PAGE 34

spa control operation

MARQUIS SPAS

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 70 71

No comments

Marquis Spas Quest Owner's Manual Page 34